Dante Glensound GTM, Детали продукта, Страница: 23 / 39

Page 23 of 39
Running Dante Controller
At the time of writing this manual the Dante Controller looks as per the screenshot
below:
The GTM will have been named at the factory during test to allow them to be identified
by the Dante controller.
The format used for the factory name is:
‘ GTM-SN- XXXX’
Where ‘GTM’ refers to the Glensound product i.e. GTM
The ‘SN - XXXX’ refers to the serial numb er of the GTM which can be found printed on
the rear or side of the unit.
The unit may be renamed in Dante controller by opening the ‘Device view’ window and
selecting GTM in the drop- down menu. Go to the ‘Device Config’ tab and change the
name with the Rename Device box.
Note if you upload a new DNT file or clear the devices config then the name will change
to ‘ GTM- xxXxXx’ whereby the ‘X’s refer to the devices MAC address.
Dante Controller TIP
If you have never run Dante controller before then make sure that on the bottom left of
the Dante controllers’ screen ‘P’ or ‘S’ is next to a green square as this indicates that it is
connected to a network. By clicking ‘P’ or ‘S’ a pop up box opens to allow you to set
what network interface the controller is using.