Page
13
of
28
NOTE: When the call level is turned fully off and muted, calling functionality is
fully disabled.
When the talk switch is off, sidetone level is adjusted when turning pot one.
3. Power LED flashes - Headphone pan control and Headphone end stop
level
In the third config mode, pot one and pot two (if using a B2) will control the
headphone panning of the respective incoming Dante audio.
During this config mode, pressing the talk switch will toggle the headphone
level end stop value. The mic activity led will show the state; Red indicates the
minimum headphone volume level is -20dBu (from 0dBu input) and Green
indicates that the headphone volume is fully off when the potentiometer is at
minimum.
On the B2 this is done by pressing both talk switches at the same time.
4. No LEDs flash
– Party mode setting
Party mode is toggled by pressing the talk switch. The mic activity LED will
indicate if party mode is enabled or disabled by illuminating either green or
red.
On a B2, the mic activity LED will illuminate orange and the respective red
channel call LEDs will flash to indicate if party mode is active. Pressing down
the talk switches will independently enable or disable party mode for each
channel.
To leave config mode, simply push the UPDATE button again to return to normal
usage. The device will exit config mode automatically after a few minutes.
Normal mode is the only state in which the PWR LED will be on solidly.
Note: In config mode, the pots will only change a value if the user turns them far
enough away from their current position. This is to avoid the levels being changed
without the users desire every time the device cycles to the next config group.