Dannmar D4-9, Инструкция по установке и эксплуатации, Страница: 48 / 85

D4-9 / D4-9X Four-Post Lifts
48
P/N 5900251 — Rev. A1— August 2021
Installing a Power Disconnect Switch
⚠
WARNING
A main Power Disconnect Switch is
not provided with this equipment.
A Power Disconnect Switch is a National Electrical Code
(NEC) requirement. It is designed to interrupt electrical
power in the event of an electrical circuit fault,
emergency situation, or when equipment is undergoing
service or maintenance.
We strongly recommend you install a Power Disconnect
Switch that is properly rated for the incoming power.
⚠
DANGER All wiring must be performed by a
licensed, certified Electrician in
accordance with local and national
electrical codes.
Your Power Disconnect Switch must be readily
accessible and installed so that it is in easy reach of the
Lift operator. It must be clearly and legibly marked to
indicate its purpose.
The drawing to the right shows a toggle Power
Disconnect Switch between the Lift’s power source and
its Power Unit. A quick flip of the switch immediately
cuts power to the Lift.
Make sure to have a certified Electrician install the Power
Disconnect Switch.
Make sure the Electrician selects a UL-listed Power
Disconnect Switch.
Installing a Thermal Disconnect Switch
⚠
WARNING
The Lift’s motor does not have thermal overload protection.
Connect a motor Thermal Disconnect Switch or overload device that will make sure the equipment
shuts down in the event of an overload or an overheated motor.
⚠
DANGER All wiring must be performed by a licensed, certified Electrician in accordance with
local and electrical codes.
High electrical current that exceeds the motor’s full load amps (FLA) rating may result in permanent
damage to the motor.
Dannmar strongly recommends that you
not
exceed the rated duty cycle of the Lift’s motor.