DANLEY OWNER’S MANUAL
Page | 5
www.danleysoundlabs.com
3.3
Switch Modes for the PG218
These subwoofers can be run two ways; Bi-amp or passive. In the passive mode, the connection is to pins +1 and -1. Pins +2 and
-2 pass through from one NL4 to the other. In Bi-amp mode, connect one amp channel to pins +1 and -1, and the other channel
to pins +2 and -2 of the same NL4. If four conductor cable is not available, you may use two runs of two conductor cable. Be
sure the switch is in Bi-amp mode or amp failure can occur.
3.4
Impedance
In the biamp mode the average impedance of the woofers will be twice the passive mode.
3.5
Rigging
If you have to ask how, you probably shouldn’t be doing it!
Safety Precautions
Before attempting to rig or suspend your Danley speakers, read and understand the following safety information.
IMPORTANT RIGGING SAFETY WARNING!
The information in this section has been assembled from recognized engineering data and is intended for informational purposes
only. None of the information in this section should be used without first obtaining competent advice with respect to applicability
to a given circumstance. None of the information presented herein is intended as a representation or warranty on the part of
Danley Sound Labs. Anyone making use of this information assumes all liability arising from such use.
All information presented herein is based upon materials and practices common to North America and may not directly apply to
other countries because of differing material dimensions, specifications, and/or local regulations. Users in other countries should
consult with appropriate engineering and regulatory authorities for specific guidelines.
Correct use of all hardware is required for secure system suspension. Careful calculations should always be performed to ensure
that all components are used within their rated workload before the array is suspended. Never exceed maximum recommended
load ratings.
