Danfoss VLT OneGearDrive, Инструкция по эксплуатации

Страница: 31 / 40

8.6 Options
8.6.1 Torque Arm Set
Part number: 178H5006
The torque arm set consists of the torque arm (see
Figure 8.13 ) and the mounting set (see Figure 8.14 ).
130BC426.11
A
A
8.17
1.77
o
30
A - A
7.28+0.008
o
5x 30
1.38
0.43
0.24
0.99+0.004
3.76+0.006
5.51
4.53
R 1.38
0.59
Figure 8.13 Torque Arm
130BC425.11
1
2 3
4
8
7
5
6
9
Position Description Specification
1 Disc DIN 125-A10 5
2 Nut DIN 934 M10
3 Disc DIN 9021 10, 5x30x25
4 Nut DIN 985 M10
5 Disc Ø73x3 Stainless steel
6 Customer frame –
7 Barrel POM-C white
8 Bushing Stainless steel
9 Screw Stainless steel
Figure 8.14 Mounting Set
NOTICE!
The set also contains 3xDIN 933, M10x25, 8.8, stainless
steel screws. The tightening torque is 49 Nm.
NOTICE!
Only use the original Danfoss or comparable mounting
set to mount the OneGearDrive to the conveyor. The
mounting equipment used must ensure the same degree
of flexibility as the original Danfoss mounting set. The
torque arm cannot be screwed directly on to the
conveyor frame.
Motor Datasheet Instruction Manual
MG75C422 Danfoss A/S © 08/2014 All rights reserved. 29
8 8