![background image](http://html.mh-extra.com/html/danfoss/vlt-mca-117/vlt-mca-117_operating-manual_508267005.webp)
1 Introduction
1.1 Purpose of this Operating Guide
This operating guide provides information for the installation, commissioning, and parameter mapping of a VLT® FCD 300 PROFIBUS
Converter MCA 117 when installed in a VLT® Decentral Drive FCD 302.
The operating guide is intended for use by qualified personnel. Users are assumed to be familiar with:
•
VLT® decentral drives.
•
PROFIBUS.
Read the instruction before installation and ensure that the instructions for safe installation are observed.
Essential information for quick installation and setup is found in:
•
•
•
3.1 Introduction to Installation
•
Detailed information including the full range of setup options and diagnosis tools is found in:
•
VLT
®
is a registered trademark for Danfoss A/S.
1.2 Additional Resources
The following manuals may be helpful when installing the VLT® FCD 300 PROFIBUS Converter MCA 117:
•
VLT® Decentral Drive FCD 302 Operating Guide.
•
VLT® Decentral Drive FCD 302 Design Guide.
•
VLT® AutomationDrive FC 301/FC 302 Programming Guide.
1.3 Document and Software Version
This manual is regularly reviewed and updated. All suggestions for improvement are welcome.
The original language of this manual is English.
NOTICE
The converter is based on the latest firmware release of the VLT® Decentral Drive FCD300 and VLT® Decentral Drive FCM300.
The firmware versions are listed in
. If the FCD/FCM drive that has to be replaced has a older version (lower number) the
converter works, but may not convert parameters correctly.
Introduction
Operating Guide | VLT® FCD 300 PROFIBUS Converter MCA 117
AQ289550754901en-000101 / 130R0890| 5
Danfoss A/S © 2019.11