Danfoss VLT FC 103, Руководство по эксплуатации

Страница: 65 / 120

130
BF210.10
Illustration 8.1 Heat Sink Access Panel Removed from the Rear
of the Drive
8.3 Status Messages
When the drive is in status mode, status messages
automatically appear in the bottom line of the LCP display.
Refer to
Illustration 8.2 . Status messages are defined in
Table 8.1 – Table 8.3 .
Status
799RPM 7.83A 36.4kW
0.000
53.2%
1(1)
Auto
Hand
Off
Remote
Local
Ramping
Stop
Running
Jogging
.
.
.
Stand-by
130BB037.11
1
2
3
1 Where the stop/start command originates. Refer to Table 8.1 .
2 Where the speed control originates. Refer to Table 8.2 .
3 Provides the drive status. Refer to Table 8.3 .
Illustration 8.2 Status Display
NOTICE
In auto/remote mode, the drive requires external
commands to execute functions.
Table 8.1 to Table 8.3 define the meaning of the shown
status messages.
Off The drive does not react to any control signal
until [Auto On] or [Hand On] is pressed.
Auto The start/stop commands are sent via the
control terminals and/or the serial communi-
cation.
Hand The navigation keys on the LCP can be used
to control the drive. Stop commands, reset,
reversing, DC brake, and other signals applied
to the control terminals override local control.
Table 8.1 Operating Mode
Maintenance, Diagnostics, a... Operating Guide
MG16P222 Danfoss A/S © 04/2018 All rights reserved. 63
8 8