Danfoss VLT DriveMotor FCP 106, Руководство по конструкции

Страница: 8 / 82

MMP Memory module programmer.
Parameter Device data and values that can be read and set
(to a certain extent).
PELV Protective extra low voltage, low voltage with
isolation. For more information, see IEC
60364-4-41 or IEC 60204-1.
PLC Programmable logic controller.
RS485 Fieldbus interface as per EIA-422/485 bus
description, which enables serial data
transmission with multiple devices.
Warning If the term is used outside the context of safety
instructions, a warning alerts to a potential
problem that a monitoring function detected. A
warning is not an error and does not cause a
transition of the operating state.
Table 1.1 Abbreviations
Conventions
•
Numbered lists indicate procedures.
•
Bullet lists indicate other information and
description of illustrations.
•
Italicised text indicates:
- Cross-reference.
- Link.
- Footnote.
-
Parameter name.
- Parameter group name.
- Parameter option.
•
All dimensions are in mm (inch).
1.4 Approvals
Frequency converters are designed in compliance with the
directives described in this section.
For more information on approvals and certificates, go to
the download area at
vlt-marine.danfoss.com/support/type-
approval-certificates/ .
Certification FCP 106 FCM 106
EC Declaration of
Conformity
✓ ✓
UL listed –
✓
UL recognized
✓
–
C-tick
✓ ✓
The EC declaration of conformity is based on the following
directives:
•
Low Voltage Directive 2006/95/EC, based on EN
61800-5-1 (2007).
•
EMC Directive 2004/108/EC, based on EN 61800-3
(2004).
UL listed
Product evaluation is complete and the product can be
installed in a system. The system must also be UL listed by
the appropriate party.
UL recognized
More evaluation is required before the combined
frequency converter and motor can be operated. The
system in which the product is installed must also be UL
listed by the appropriate party.
1.4.1 What is Covered
The EU document, Guidelines on the Application of Council
Directive 2004/108/EC , outlines 3 typical cases.
•
The frequency converter is sold directly to the
end user. For such applications, the frequency
converter must be CE labelled in accordance with
the EMC Directive.
•
The frequency converter is sold as a part of a
system. It is being marked as complete system,
such as an air-conditioning system. The complete
system must be CE labelled in accordance with
the EMC Directive. The manufacturer can ensure
CE compliance under the EMC Directive by
testing the EMC of the system. The components
of the system do not need to be CE marked.
•
The frequency converter is sold for installation in
a plant. It could be a production or a heating/
ventilation plant designed and installed by
professionals of the trade. The frequency
Introduction
VLT
®
DriveMotor FCP 106/FCM 106
6 Danfoss A/S © 06/2016 All rights reserved. MG03M202
1 1