Danfoss VLT DriveMotor FCP 106, Руководство по конструкции

Страница: 10 / 82

1.4.3 C-tick Compliance
Illustration 1.2 C-tick
The C-tick label indicates compliance with the applicable
technical standards for Electromagnetic Compatibility
(EMC). C-tick compliance is required for placing electrical
and electronic devices on the market in Australia and New
Zealand.
The C-tick regulatory is about conducted and radiated
emission. For frequency converters, apply the emission
limits specified in EN/IEC 61800-3.
A declaration of conformity can be provided on request.
1.4.4 UL Compliance
Illustration 1.3 UL Listed
Illustration 1.4 UL Recognized
The frequency converter complies with UL 508C thermal
memory retention requirements. For more information,
refer to
chapter 3.3.9 Motor Thermal Protection .
1.4.5 Export Control Regulations
Frequency converters can be subject to regional and/or
national export control regulations.
The frequency converters that are subject to export control
regulations are classified by an ECCN number.
The ECCN number is provided in the documents
accompanying the frequency converter.
In case of re-export, it is the responsibility of the exporter
to ensure compliance with the relevant export control
regulations.
1.5 Software Version
Read the software version of the frequency converter in
parameter 15-43 Software Version .
1.6 Disposal Instructions
Equipment containing electrical components
must not be disposed of together with domestic
waste.
It must be separately collected with electrical
and electronic waste according to local and
currently valid legislation.
1.7 Safety
1.7.1 General Safety Principles
If handled improperly, frequency converters have the
potential for fatal injury as they contain high-voltage
components. Only qualified personnel should install and
operate the equipment. Do not attempt repair work
without first removing power from the frequency converter
and waiting the designated amount of time for stored
electrical energy to dissipate.
Strict adherence to safety precautions and notices is
mandatory for safe operation of the frequency converter.
Correct and reliable transport, storage, installation,
operation, and maintenance are required for the trouble-
free and safe operation of the frequency converter. Only
qualified personnel are allowed to install and operate this
equipment.
Qualified personnel are defined as trained staff, who are
authorized to install, commission, and maintain equipment,
systems, and circuits in accordance with pertinent laws and
regulations. Additionally, the qualified personnel must be
familiar with the instructions and safety measures
described in these operating instructions.
WARNING
HIGH VOLTAGE
Frequency converters contain high voltage when
connected to AC mains input, DC supply, or load sharing.
Failure to perform installation, start-up, and maintenance
by qualified personnel can result in death or serious
injury.
•
Only qualified personnel must perform instal-
lation, start-up, and maintenance.
Introduction
VLT
®
DriveMotor FCP 106/FCM 106
8 Danfoss A/S © 06/2016 All rights reserved. MG03M202
1 1