5.4.8 Mounting the GLCP
Use the GLCP adapter (ordering number: 132B0281) and a
cable to connect the LCP 102 to frequency converter, as
shown in
.
130BD532.10
Illustration 5.11 GLCP Adapter and Connecting Cable
5.4.9 Backing Up/Downloading Parameters
with LCP
Establishing the correct programming for applications
often requires setting functions in several related
parameters. Parameter details are provided in
chapter 9.2 Parameter Menu Structure
.
Programming data is stored internally in the frequency
converter.
•
For back-up, upload data into the LCP memory.
•
To download data to another frequency
converter, connect the LCP to that unit and
download the stored settings.
•
Restoring factory default settings does not
change data stored in the LCP memory.
Back-up/download process
1.
Press [Off] on GLCP or [Off Reset] on NLCP to stop
the motor before uploading or downloading data.
2.
Press [Main Menu]
parameter 0-50 LCP Copy
and
press [OK].
3.
Select
[1] All to LCP
to upload data to the LCP, or
select
[2] All from LCP
to download data from the
LCP, or select
[3] Size indep. from LCP
to download
motor size independent parameters from LCP.
4.
Press [OK]. A progress bar shows the uploading or
downloading progress.
5.
Press [Hand On] or [Auto On] to return to normal
operation.
5.4.10 Restoring Default Settings with LCP
NOTICE
Risk of losing programming, motor data, localization, and
monitoring records by restoration of default settings. To
provide a back-up, upload data to the LCP before initiali-
zation.
Restoring the default parameter settings is done by initiali-
zation of the frequency converter. Initialization is carried
out through
parameter 14-22 Operation Mode
(recommended) or manually. Initialization does not reset
the settings for
parameter 1-06 Clockwise Direction
and
parameter 0-03 Regional Settings
.
•
Initialization using
parameter 14-22 Operation
Mode
does not reset frequency converter settings,
such as operating hours, serial communication
selections, fault log, alarm log, and other
monitoring functions.
•
Manual initialization erases all motor,
programming, localization, and monitoring data,
and restores factory default settings.
Recommended initialization procedure, via
parameter 14-22 Operation Mode
1.
Select
parameter 14-22 Operation Mode
and press
[OK].
2.
Select
[2] Initialisation
and press [OK].
3.
Remove power to the unit and wait until the
display turns off.
4.
Apply power to the unit.
Default parameter settings are restored during start-up.
This may take slightly longer than normal.
5.
Alarm 80, Drive initialised to default value
is shown.
6.
Press [Reset] to return to operating mode.
Commissioning
Quick Guide
MG06A702
Danfoss A/S © 03/2017 All rights reserved.
29
5
5
