Danfoss VLT AutomationDrive FC 360, Быстрое руководство

Страница: 25 / 78

Key Function
9 [Back]
For moving to the previous step or layer
in the navigation structure.
10 [
▲
] [
▼
]
For switching between parameter groups,
parameters, and within parameters, or
increasing/decreasing parameter values.
Arrows can also be used for setting local
reference.
11 [OK]
Press to access parameter groups or to
enable a selection.
12 [
►
]
Press to move from left to right within
the parameter value to change each digit
individually.
Table 5.3 Legend to Illustration 5.2 , Navigation Keys
D. Operation keys and indicator lights (LEDs)
Key Function
13 Hand On
Starts the frequency converter in local control.
•
An external stop signal by control input or
serial communication overrides the local
hand on.
14 Off/Reset
Stops the motor but does not remove power
to the frequency converter, or resets the
frequency converter manually after a fault has
been cleared. If in alarm mode, the alarm is
reset if the alarm condition is removed.
15 Auto On
Puts the system in remote operational mode.
•
Responds to an external start command by
control terminals or bus communication.
Table 5.4 Legend to Illustration 5.2 , Section D
WARNING
HIGH VOLTAGE
Touching the frequency converter after pressing the [Off/
Reset] key is still dangerous, because the key does not
disconnect the frequency converter from the mains.
•
Disconnect the frequency converter from the
mains and wait for the frequency converter to
fully discharge. See the discharge time in
Table 2.1 .
5.4.2 The Right-key Function on NLCP
Press [
►
] to edit any of the 4 digits on the display
individually. When pressing [
►
] once, the cursor moves to
the first digit and the digit starts flashing as shown in
Illustration 5.4 . Press the [
▲
] [
▼
] to change the value.
Pressing [
►
] does not change the value of the digits or
move the decimal point.
130BC440.10
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Illustration 5.4 Right-key Function
[
►
] can also be used for moving between parameter
groups. When in Main Menu , press [
►
] to move to the first
parameter in the next parameter group (for example, move
from
parameter 0-03 Regional Settings [0] International to
parameter 1-00 Configuration Mode [0] Open loop ).
5.4.3 Quick Menu on NLCP
The Quick Menu gives easy access to the most frequently
used parameters.
1. To enter Quick Menu , press [Menu] until the
indicator in display is placed above Quick Menu .
2.
Press [
▲
] [
▼
] to select either QM1 or QM2, then
press [OK].
3. Press [
▲
] [
▼
] to browse through the parameters in
Quick Menu .
4. Press [OK] to select a parameter.
5. Press [
▲
] [
▼
] to change the value of a parameter
setting.
6. Press [OK] to accept the change.
7. To exit, press either [Back] twice (or 3 times if in
QM2 and QM3) to enter
Status , or press [Menu]
once to enter Main Menu .
Commissioning Quick Guide
MG06A702 Danfoss A/S © 03/2017 All rights reserved. 23
5 5