Danfoss VLT AutomationDrive FC 300, Руководство по программированию

Страница: 32 / 219

3.2.5 0-4* LCP Keypad
Enable, disable and password protect individual keys on the
LCP.
0-40 [Hand on] Key on LCP
Option: Function:
[0]
*
Disabled No effect when [Hand on] is pressed. Select
[0] Disabled to avoid accidental start of the
drive in
Hand on mode.
[1]
*
Enabled The LCP switches to Hand on mode directly
when [Hand on] is pressed.
[2] Password After pressing [Hand on] a password is
required. If
0-40 [Hand on] Key on LCP is in
included in My Personal Menu , define the
password in 0-65 Quick Menu Password .
Otherwise define the password in 0-60 Main
Menu Password .
[3] Hand Off/On When [Hand on] is pressed once, the LCP
switches to
Off mode. When pressed again,
the LCP switches to Hand on mode.
[4] Hand Off/On w.
Passw. Same as [3] but a password is required (see
[2]).
[9] Enabled, ref = 0
0-41 [Off] Key on LCP
Option: Function:
[0]
*
Disabled Avoids accidental stop of the frequency
converter.
[1]
*
Enabled
[2] Password Avoids unauthorised stop. If 0-41 [Off] Key on LCP is
included in the Quick Menu, then define the
password in
0-65 Quick Menu Password .
0-42 [Auto on] Key on LCP
Option: Function:
[0]
*
Disabled Avoid accidental start of the frequency converter
in Auto mode.
[1]
*
Enabled
[2] Password Avoids unauthorised start in Auto mode. If
0-42 [Auto on] Key on LCP is included in the Quick
Menu, then define the password in 0-65 Quick
Menu Password .
0-43 [Reset] Key on LCP
Option: Function:
[0]
*
Disabled No effect when [Reset] is pressed. Avoids
accidental alarm reset.
[1]
*
Enabled
[2] Password Avoids unauthorised resetting. If
0-43 [Reset] Key on LCP is included in the
Quick Menu, then define the password in
0-65 Quick Menu Password .
0-43 [Reset] Key on LCP
Option: Function:
[7] Enabled
without OFF Resets the drive without setting it in Off
mode.
[8] Password
without OFF Resets the drive without setting it in Off
mode. A password is required when
pressing [Reset] (see [2]).
3.2.6 0-5* Copy / Save
Copy parameter settings between set-ups and to/from the
LCP.
0-50 LCP Copy
Option: Function:
[0]
*
No copy
[1] All to LCP Copies all parameters in all set-ups
from the frequency converter memory
to the LCP memory.
[2] All from LCP Copies all parameters in all set-ups
from the LCP memory to the frequency
converter memory.
[3] Size indep. from
LCP Copy only the parameters that are
independent of the motor size. The
latter selection can be used to
programme several frequency
converters with the same function
without disturbing motor data.
[4] File from MCO to
LCP
[5] File from LCP to
MCO
[6] Data from DYN to
LCP
[7] Data from LCP to
DYN
This parameter cannot be adjusted while the motor is
running.
Parameter Descriptions FC 300 Programming Guide
MG.33.MB.02 - VLT
®
is a registered Danfoss trademark 31
3 3