Danfoss VLT AutomationDrive FC 300, Инструкция по эксплуатации, Страница: 51 / 98

53
55
6-1*
+
A53
U - I
130BB482.10
0-10V
Figure 5.10 Wiring Example for External Device Providing 0–10 V
Control Signal
5.3 Control Terminal Programming
Examples
Control terminals can be programmed.
•
Each terminal has specified functions it is capable
of performing.
•
Parameters associated with the terminal enable
the function.
•
For proper adjustable frequency drive
functioning, the control terminals must be
wired properly
programmed for the intended function
receiving a signal
See Table 5.1 for control terminal parameter number and
default setting. (Default setting can change based on the
selection in
0-03 Regional Settings ).
The following example shows accessing Terminal 18 to see
the default setting.
1. Press [Main Menu] twice, scroll to parameter
group
5-** Digital In/Out and press [OK].
130B
T768.10
2-** Brakes
3-** Reference / Ramps
4-** Limits / Warnings
5-** Digital In/Out
14.6% 0.00A 1(1)
Main Menu
Figure 5.11
2. Scroll to parameter group 5-1* Digital Inputs and
press [OK].
130B
T769.10
5-0* Digital I/O mode
5-1* Digital Inputs
5-4* Relays
5-5* Pulse Input
14.7% 0.00A 1(1)
Digital In/Out 5-**
Figure 5.12
3. Scroll to 5-10 Terminal 18 Digital Input . Press [OK]
to access function choices. The default setting
Start is shown.
5-1*
130B
T770.10
5-10 Terminal 18 Digital
Input
[ 8 ]] Start
14.7% 0.00A 1(1)
Digital Inputs
Figure 5.13
5.4 International/North American Default
Parameter Settings
Setting 0-03 Regional Settings [0] International or [1] North
America changes the default settings for some parameters.
Table 5.1 lists those parameters that are affected.
Parameter International
default parameter
value
North American
default parameter
value
0-03 Regional
Settings International North America
0-71 Date Format DD-MM-YYYY MM/DD/YYYY
0-72 Time Format 24 h 12 h
1-20 Motor Power
[kW] See Note 1 See Note 1
1-21 Motor Power
[HP] See Note 2 See Note 2
1-22 Motor Voltage 230 V/400 V/575 V 208 V/460 V/575 V
1-23 Motor
Frequency 50 Hz 60 Hz
3-03 Maximum
Reference 50 Hz 60 Hz
3-04 Reference
Function Sum External/Preset
Programming
VLT
®
Automation Drive D-Frame
Instruction Manual
MG34U222 - VLT
®
is a registered Danfoss trademark 5-3
5 5