Danfoss VACON NXS Air-cooled, Руководство по эксплуатации

Страница: 113 / 196

•
•
•
•
•
1.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
8.7.7 Keypad Settings
8.7.7.1 Finding the Keypad Settings Menu
Use the Keypad settings submenu in the System menu for making changes in the control panel.
In the submenu, there are 5 pages (P#) that control the panel operation:
Default page ( P6.6.1 )
Default page/Operating menu ( P6.6.2 )
Timeout time ( P6.6.3 )
Contrast adjustment ( P6.6.4 )
Backlight time ( P6.6.5 )
Procedure
In the System menu ( M6 ), find the Keypad settings submenu ( S6.6 ) with the Browser buttons.
8.7.7.2 Changing the Default Page
Use the Default page to set the location (page) to which the display automatically moves after the Timeout time or after the panel is
set on.
For more information on the timeout time, see
8.7.7.4 Setting the Timeout Time .
If the Default Page value is 0, the function is not activated. When the Default page is not used, the control panel shows the page
that was last showed on the display.
Procedure
In the Keypad settings submenu, find the Default page subpage ( P6.6.1 ) with the Browser buttons.
To go to the edit mode, push the Menu button Right.
To change the number of the main menu, use the Browser buttons.
To edit the number of the submenu/page, push the Menu button Right. Change the number of the submenu/page with
the Browser buttons.
To edit the third level page number, push the Menu button Right. Change the number of the third level page with the
Browser buttons.
To accept the new default page value, push the [enter] button.
8.7.7.3 Default Page in the Operating Menu (P6.6.2)
Use this submenu to set the default page in the Operating menu. The display automatically moves to the set page after the Timeout
time (see
8.7.7.4 Setting the Timeout Time ) or after the control panel is set on. For instructions, see 8.7.7.2 Changing the Default
Page .
The Operating menu is only available in special applications.
8.7.7.4 Setting the Timeout Time
The Timeout time sets the time after which the control panel display goes back to the Default page ( P6.6.1 ), see 8.7.7.2 Changing the
Default Page .
If the Default page value is 0, the Timeout time setting has no effect.
Procedure
In the Keypad settings submenu, find the Timeout time subpage ( P6.6.3 ) with the Browser buttons.
To go to the Edit mode, push the Menu button Right.
To set the timeout time, use the Browser buttons.
To accept the change, push the [enter] button.
8.7.7.5 Contrast Adjustment (P6.6.4)
If the display is not clear, adjust its contrast with the same procedure as the one for the timeout time setting, see 8.7.7.4 Setting the
Timeout Time .
AQ275638903263en-000601 / DPD00910 | 113 Danfoss A/S © 2022.12
Using the Control Panel
VACON® NXS/NXP Air-cooled
Operating Guide