•
•
P2.3.7.2
(Multi-Purpose Control Application)
P2.3.5.2
(Pump and Fan Control Application)
Use this parameter to add offset to the analog output 3.
Add -100.0% to 100.0% to the analog output signal.
See
10.131 (ID 375) Analog Output 1 Offset
10.223 (ID 485) Scaling of Motoring Torque Limit
Location in the menu:
P2.2.6.5
(Multi-purpose Control Application)
Use this parameter to select the signal that adjusts the maximum motor torque limit.
For selection 5 "Fieldbus (FBProcessDataIN2)", see
10.624 Fieldbus Control Parameters (IDs 850–859)
100%
ID349
0
e
3
0
b
h
0
4
6
.1
0
A
B
C
Illustration 65: Scaling of Motoring Torque Limit
10.224 (ID 486) Digital Output 1 Signal Selection
Location in the menu:
P2.3.1.1
(Multi-Purpose Control Application)
Use this parameter to connect the digital output signal to the digital output of your selection.
TTF programming method must be applied to this parameter (see
10.626 "Terminal to Function" (TTF) Programming Principle
Use Control options, parameter
ID 1084
to invert the Digital output function.
10.225 (ID 487) Digital Output 1 On-Delay
Location in the menu:
P2.3.1.3
(Multi-Purpose Control Application)
Use this parameter to set the ON delay for the digital output.
See
10.226 (ID 488) Digital Output 1 Off-Delay
Location in the menu:
P2.3.1.4
(Multi-Purpose Control Application)
Use this parameter to set the OFF delay for the digital output.
e
3
0
b
h
0
6
2
.1
0
A
B
C
D
Illustration 66: Digital Outputs 1 and 2, On- and Off-Delays
AB296635287482en-000301 / DPD00903
228 | Danfoss A/S © 2023.02
Parameter Descriptions
VACON® NX All-in-One
Application Guide
Содержание VACON NX
Страница 1: ...Application Guide VACON NX All in One drives danfoss com...
Страница 2: ......