1
vacon • 2
Vacon 20 X - Simple operator panel
1.1.2
Installation
Figure 2. Cover open.
1
•
Remove the cover from the drive. See the Figure 2.
2
•
Open only the inlet holes where you need to run the cables. Cables pass
through this inlet hole.
3
•
Connect the supply cable to the Mains switch passing through the cable gland
from the bottom side (use the cable gland for sealing the cable to the drive)
and then through the terminal box as shown in the figure below.
4
•
Place the Simple Operator panel assembly with the cables inside the drive and
fix it with its screws.
5
•
Connect the cables from the Mains switch to the line terminals. The cables
have to be connected to the terminals L1, L2 and L3.
6
•
Fix the cables with the cable clamp.
