Fig.1
Space for additional
logo if required
TP9
User Instructions
Fig.2
Before programming the thermostat press the + & – AND
▲
&
▼
buttons
simultaneously to reset the unit (Fig.1)
Setting the Clock and Day
1) CLOCK - Press PROG (Fig.2) to begin programming
Use + or – buttons (Fig.3) to adjust the TIME (Fig.4)
2) DAY - Press PROG again (Fig.2)
Use + or – buttons (Fig.3) until correct DAY is shown (MO = Monday) (Fig.5)
Accepting the Factory Pre-settings
The TP9 has pre-set times already programmed in for controlling the heating
and hot water, which often suit most people (see Table below & Fig.12 over).
To accept these settings press the PROG button until the time appears in the
display and colon begins to flash - the unit is now in RUN mode (Fig.6).
If you wish to alter these settings follow instructions below.
Your installer will have set your unit to operate in one of the following modes:
5/2 day - one set of programmes for weekdays and another for weekends
24 hour - one set of programmes for the whole week
Programming your CENTRAL HEATING
For Days 1-5 (weekdays)
a) Press PROG (Fig.2) 3 times to show the 1
st
pre-set time and temperature
(Event 1 Days 1,2,3,4,5) (Fig.7)
b) Use + or – buttons to adjust the TIME (press and hold to change in 10 min
increments)
c) Use
▲
or
▼
buttons to adjust the TEMPERATURE (Fig.8)
d) Press PROG (Fig.2) to move to next preset time & temp (Event 2) (Fig.9)
e) Repeat steps b, c & d for programming Events 3, 4 5 & 6
For Days 6-7 (weekends)
●
Press PROG (Fig.2) to show 1
st
pre-set time and temperature (Event 1 Days
6-7) (Fig.10)
●
Repeat steps b, c and d above to programme time and temperatyure
events for the weekend
NB. Left hand LED will be lit when the Central Heating programme is running
Fig.7
Fig.5
Fig.3
Fig.4
Fig.8
Mon-Sun (24 hour mode)
Mon-Fri (5/2 day mode)
Sat-Sun (5/2 day mode)
Event
Time
Temp°C
Event
Time
Temp°C
1
06.30
20
1
07.00
20
2
08.30
16
2
10.00
16
3
12.30
19
3
12.00
19
4
13.30
16
4
14.00
16
5
17.30
21
5
17.00
21
6
22.30
16
6
22.30
16
Fig.6
Fig.9
Fig.10
