Fig.1
TP5000 Si/TP5000 RF Si
User Instructions
Mon-Fri
Sat-Sun
Fig.2
Before programming the thermostat press and release the
RESET
button to restart
the unit.
(Fig. 1)
Setting the Clock and Day
The day and time are set in the factory and therefore it will not normally be necessary
to do this on site. Changes between summer and winter time are handled automatically
by the unit.
Accepting the Factory Pre-settings
The TP5000 Si has pre-set times already programmed in, which often suit most people
(see table below).
Note: If set up for 4 events per day, events 3 & 4 are skipped. If set up for 2 events per
day, events 2, 3, 4 & 5 are skipped and the events are re-numbered.
To adjust the factory pre-settings & set your own time and temperature
programmes
For Days 1-5 (weekdays)
a) Press
PROG
(Fig. 2)
until the 1
st
pre-set time and temperature
(Event 1 Days 1,2,3,4,5)
(Fig. 3)
.
b) Use
+ or –
buttons
(Fig. 4)
to adjust the
TIME
(press and hold to change in 10 min
increments).
c) Use
Λ or V
buttons
(Fig. 5)
to adjust the
TEMPERATURE
.
d) Press
PROG
(Fig. 2)
to move to next preset time & temp (Event 2)
(Fig. 6)
.
e) Repeat steps b, c & d for programming Events 3, 4, 5 & 6.
For Days 6-7 (weekends)
Press
•
PROG (Fig. 2)
to show 1
st
pre-set time and temperature
(Event 1 Days 6-7)
(Fig. 7)
.
Repeat steps b, c and d above to programme time and temperature events for
•
the weekend.
Returning to RUN mode
Press
PROG (Fig. 2)
– the colon in the LCD display will start to flash
(Fig. 8)
.
Fig.5
Fig.4
Fig.6
Fig.7
Fig.8
Event
Time
Temp. °C
1
06:30
20
2
08:30
15
3
11:30
20
4
13:30
15
5
16:30
21
6
22:30
15
Event
Time
Temp. °C
1
07:30
20
2
09:30
20
3
11:30
20
4
13:30
20
5
16:30
20
6
22:30
15
RESET
Fig.3
Complete Shut off - Summer time
Press Λ and V together to enter thermostat mode. A frost protection symbol (snowflake in a
shield) will appear in the display . Press the down arrow
∨
once,
OFF
will appear in the display.
To return to automatic programming press both
∧
and
∨
together.
