•
When in a hospital or other health care facility, observe the restrictions on the use of cellular
communication equipment. Switch CS500 unit off, if instructed to do so by the guidelines posted in
sensitive areas.
The operation of cardiac pacemakers, other implanted medical device and hearing aids can be affected
by interference from CS500 unit's antennas placed close to the device.
•
If in doubt about potential danger, contact a physician or the manufacturer of the implanted medical
device to verify that it is properly shielded. Pacemaker patients are advised to keep CS500 unit and its
antennas away from the pacemaker while it is on.
Air traffic
Danger of interference caused by RF energy.
The operation of wireless appliances in an aircraft is forbidden to prevent interference with
communications systems. Failure to observe these instructions may lead to the suspension or denial of
cellular services to the offender, legal action, or both.
•
Switch the unit off before boarding an aircraft.
•
Make sure it cannot be switched on inadvertently.
Explosives
Danger of explosion.
Operation of any electrical equipment in potentially explosive atmospheres can constitute a safety
hazard.
•
Observe the applicable regulations and precautions when you are near explosive areas (i.e. petrol
stations, fuel depots, chemical plants or where blasting operations are in progress).
•
Do not mount the antenna in the close environment of fuel tanks, vessels with explosives and
insufficiently shielded electronic devices.
Antennas
Danger due to absorption of RF energy.
Mobile communication devices may pose a health risk when operated in close proximity of persons.
•
Install the device with integrated antenna(s) used for the CS500 to provide a separation distance of at
least 20 cm / 8 inches from all persons.
•
Do not operate them in conjunction or co-locate them with any other antenna or transmitter.
Electronic equipment
Danger of interference caused by RF energy
The unit receives and transmits radio frequency energy while switched on. Interference may occur if it is
used close to TV sets, radios, computers or inadequately shielded equipment.
Follow any special regulations and always switch off the unit wherever use is forbidden, or when you
suspect that it may cause interference or danger.
Avoid property damage
W
Warning
Property damage may occur, and unintended movement of machine or mechanism may cause injury to
the technician or bystanders. Before any installation of the Control system, turn ignition lock off and
disconnect the battery. Before handling the device disconnect externally. Also, disconnect independently
supplied output load circuits.
Technical Information
PLUS+1® Connect CS500 IoT Gateway
Safety information
©
Danfoss | October 2021
BC397226723595en-000101en-000101 | 11
