Valve label ID:
4
5
Valve size setup (mandatory)
Programming the ICAD
Changing analogue input signal (optional)
Decrease
value
Edit /
Enter
Increase
value
Hold down for
2 seconds to enter
programming mode.
; 01
; 10
Press and
go to parameter 10.
Press
Press until
you reach 11 (pass-
word). Press
Press until
you reach parameter 26
Press
11
; 26
Press or
to select ICM size.
Press
ICM / ICAD is now
calibrating.
0
; 26
CA
Hold down for
2 seconds to exit
programming mode.
1: ICM 20 with ICAD 600
2: ICM 25 with ICAD 600
3: ICM 32 with ICAD 600
4: ICM 40 with ICAD 900/1200
5: ICM 50 with ICAD 900/1200
; 01
Hold down for
2 seconds to enter
programming mode.
; 03
Press until you
reach parameter 03.
Press
Press or
to select analogue
input signal.
1: 0-20 mA
2: 4-20 mA*
3: 0-10 V
4: 2-10 V
2
; 03
Press
A3
If A3 alarm occurs
the analogue input
signal is out of range.
For further functions,
programming possibilities
and factory settings;
please see ICAD instruction.
24 Volt d.c. ONLY
2
DKRCI.PI.HV0.J2.02 / 520H4887 / 027R9801
©
Danfoss A/S (AC-SMC/MWA), 05 - 2011
Note:
If the keypad is not operated within 20 seconds;
time out will automatically exit programming mode.
Hold down for
2 seconds to exit
programming mode.
* default factory setting
; 03
ICM 20
ICM 25-65
ICM 100-150
6: ICM 65 with ICAD 900/1200
7: ICM 100 with ICAD 1200
8: ICM 125 with ICAD 1200
9: ICM 150 with ICAD 1200
When powering up the ICAD, A1 will flash in the display
Factory reset of ICAD
Disconnect power
Press down and
simultaneously while
reconnecting power
Release and
Note:
If factory reset has been performed the
ICAD will start flashing A1 in the display.