manualshive.com logo in svg

Danfoss MCD LCP 501, Инструкции, Страница: 2 / 4

Поделиться
Скачать
Danfoss MCD LCP 501 Скачать руководство пользователя страница 2

Instructions: Control Panel LCP 501 

MI.17.G1.02 - VLT is a registered Danfoss trademark 

 

4.

 

Mounting the LCP 

 

 

Models MCD5-0021 to MCD5-0105: The LCP can be removed or 
replaced while the starter is running.  It is not necessary to remove 
mains or control voltage. 
Models MCD5-0131 to MCD5-1600: The bus bar and/or heatsink are 
live whenever mains voltage is connected.  Remove mains and 
control voltage from the soft starter before removing the cover. 

 

 

1.

 

Use the template to drill four mounting holes and two holes for the 
DB9 connector. 

2.

 

Apply the foam gasket to the back of the LCP. 

3.

 

Align the LCP over the holes and screw in place. 

17

7H

A

61

4.

10

 

4.

 

Plug the cable into the LCP and the soft starter.   

177HA615.10

 

177HA616.10

 

MCD5-0021 to MCD5-0105 

MCD5-0131 to MCD5-1600 

 
    

 

Содержание MCD LCP 501

Страница 1: ... metres away from the soft starter allowing remote control and monitoring The LCP is rated IP65 when mounted correctly in accordance with these instructions 2 Packing List 1 x LCP 4 x M3 x 16 Screw 1 x Cable DB9 3 metres 4 x M3 Flat washer 1 x Gasket foam 4 x M3 Spring washer 1 x Instruction sheet 4 x M3 Nut 2 x Jack screw 3 Specifications Maximum cable length 3 metres Protection IP65 and NEMA12 ...

Страница 2: ...CD5 1600 The bus bar and or heatsink are live whenever mains voltage is connected Remove mains and control voltage from the soft starter before removing the cover 1 Use the template to drill four mounting holes and two holes for the DB9 connector 2 Apply the foam gasket to the back of the LCP 3 Align the LCP over the holes and screw in place 177HA614 10 4 Plug the cable into the LCP and the soft s...

Страница 3: ...ly been used with a MCD 500 the operator can select whether to copy the parameters to the starter or to copy the MCD 500 s parameter settings into the LCP Select the required option using the and buttons The selected option is surrounded by a dotted line Press OK to proceed with the selection Copy Parameters Display to Starter Starter to Display If the parameter software version in the LCP is diff...

Страница 4: ...501 MI 17 G1 02 VLT is a registered Danfoss trademark 6 Mounting template Drill four mounting holes for screws one in each corner and two holes for the DB9 connector 12 7 mm 177HA613 10 25 mm diameter 25 mm 13 mm 136 mm 4 mm diameter ...

Отзывы:

Нет отзывов