After forming heavy fittings, the locking bolt may be slightly slug-
gish. In this case, use a mallet to release the locking bolt by
slightly hitting on the die wrench.
5.5 Adjusting the depth stop
The depth stop must be adjusted specifically for the work piece.
When inserting the hose, the crimping process is triggered by contact
with the stop cone. When the pre-defined forming diameter or forming
pressure is reached, the tool will stop automatically. Remove depth
stop for special applications, e.g. pipe bends.
1.
Replace the screws (1) by the cylinder bolt, the washer and the
circlip.
Содержание ET4350
