Danfoss ED-DT318B, Инструкция по установке и эксплуатации

Страница: 22 / 186

Installation and Operation Guide
ED-DT318B
Drive Train Systems with Traction Control, Inverter/Controller, and Motor with 2 Speed Transmission
BC353060341319en-000101 Revision D © Danfoss | November 2020 | 21
Classified as Business
Contact:
吴 坚
(Wu Jian)
Cell Phone: 13661717371
Fluid Name: 2979
Eaton does not approve mineral oil lubricants by brand name.
Additives or friction modifiers which are not part of the original lubricant are not recommended.
The use of lubricants not meeting these requirements will affect warranty coverage.
Buy from a reputable dealer.
2.4.1.2 Lubrication Information
Proper lubrication procedures are the key to a good all-around maintenance program.
Eaton Transmissions are designed so that the internal parts operate in an oil circulating bath created by the
motion of the gears and shafts.
All parts will be properly lubricated if these procedures are closely followed:
•
Maintain oil level. Inspect regularly.
• Follow maintenance interval recommendations below.
•
Use the brand recommended by the vehicle manufacturer.
2.4.1.3 Maintain Proper Oil Level
Make sure oil is level with the filler opening. Being able to reach oil with your finger does not mean oil is at
proper level. The proper level is shown in
Figure 2.6 .
Never mix different brands of oil.
Figure 2.6: Proper lubricant level
2.4.1.4 Operating Temperature
It is important that the transmission operating temperature does not exceed 120°C (250°F) for an extended
period of time. Operating temperatures above 120°C cause breakdown of the oil and shorten transmission life.
The following conditions in any combination can cause operating temperatures of over 120°C:
•
Operating consistently at road speeds under 32 km/h (20m.p.h.)
•
High engine RPM
•
High ambient temperature
• Restricted air flow around transmission
•
High torque in low gear or reverse operation
•
High power PTO operation for extensive periods while stationary