Danfoss District Energy
DSA 1 MINI -
2
DEN-SMT/PL
VM.HE.B2.02
Danfoss District Energy
2.0 Safety note
This section provides you with an overview of all relevant
safety aspects for optimum protection for you and your
personnel and the safe and fault-free operation of the unit.
The individual sections also contain specific, symbol-
-identified safety notes for averting immediate dangers.
General
The unit is built in accordance with the sound engineering
practise and follow all relevant EU regulations applicable
at the time of its development and production. The unit
can, however, entail dangers if it is used by unskilled or not
properly trained personnel or is used improperly or not as
intended.
Every person assigned to work on or with the unit must
therefore have read and understood the operating
instructions before the work begins. The operator is
recommended to have all relevant personnel confirm the
understanding of the operating instructions in writing.
Changes of any kind and additions to or conversions on
the unit are strictly forbidden, and all warranty and product
responsibly will on longer by covered by Danfoss District
Energy.
Operator/owner’s responsibility
• Always keep operating instructions close to the unit and
accessible for the installation, operating, maintenance
and cleaning personnel at all times.
• Only operate the unit within the product specified
pressure and temperature limits.
• Always keep safety devices freely accessible and check
regularly.
The information on safety at work applies to the European
Union ordinances and is applicable at the time the unit is
produced. The operator is obliged to determine the compli-
ance of the safety at work rules and regulations and must
observe and updated if new regulations is adopted by the
EU during the entire time of the unit’s life time.
Outside the EU the applicable safety at work legislation
and regional provisions and regulations must be complied.
In addition to the safety at work, notes in these operating
instructions, and the generally applicable safety, accident-
prevention and environmental protection regulations must
be observed and complied with for the specific area of
application.
The operator and the authorised personnel are responsible
for the fault-free operation of the unit, and for the clear
definition of responsibilities with the unit’s installation,
operation, maintenance and cleaning. The information
provided in the operating instructions must be followed
in full and unrestricted!
The operator must also ensure that:
- All residual risk that arises as a result from the point of
installation must be determined and minimized.
Safety note
Please always agree conversion and extension work
with the manufacturer.
All safety, warning and operating
notices on the unit must always be kept in an easy to
read condition. Damaged signs or stickers must be
renewed immediately. Given setting values or ranges
must be observed.