18
VLT is a registered Danfoss trademark
Appendix
BACnet POINT MAPPING TABLES
for BACLink PORTAL
Binary Inputs to Drive
The values in
bold
are
default values.
NOTE
Binary input point 9 commands two different
functions. For VLT 2800, it commands
reverse function to change direction of
motor rotation. For VLT 6000, it can
command the state of Form C relay.
BACnet
REFERENCE NUMBER
DESCRIPTION
RANGE
coast_#
Motor will coast freely to a stop.
Drive will not run in any mode
when coast is active.
0=Coast stop 1=No
coast
start_#
Provides a start command when
active. Motor will ramp to stop
when stop is active.
0=Stop 1=Start
reset_#
Allows resetting drive after a fault
that does not require cycling
power. Reset occurs at transition
from OFF to ON.
0=Off 1=On
jog_#
Used to start and run drive at a
frequency set in parameter 209.
0=Off 1=On
vlt2800_relay_# Enables/disables
high
voltage
Form C relay when parameter 323
is set to Control Word Bit 11 [26]
(for VLT 2800 only).
0=Off 1=On
vlt6000_relay_2_#
Enables/disables low voltage
Form A relay when parameter 323
is set to Control Word Bit 11/12
[29] (for VLT 6000 only).
0=Off 1=On
vlt6000_reverse_#
Changes motor direction of
rotation when parameter 506 is set
to a value other than Digital Input
(for VLT 6000 only).
0=Off 1=On
relay_1_and_reverse_#
For VLT 2800, changes motor
direction of rotation.
For VLT 6000, enables/disables
high voltage Form C relay when
parameter 323 is set to Control
Word Bit 11/12 [29].
0=Off 1=On