1 Introduction
1.1 Purpose of the Design Guide
This design guide introduces important aspects of the VLT
®
Advanced Harmonic Filters AHF 005/AHF 010 (referred to
as AHF) for VLT
®
FC Series frequency converters. It
describes harmonics and how to mitigate them, and it
provides installation instructions and guidance on how to
program the frequency converter.
The technical data and information on the connection
conditions are on the nameplate and in the documen-
tation. Always observe the recommendations and
instructions in this document.
Danfoss technical documentation is also available online at
1.2 Document Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome.
shows the document version.
Edition
Remarks
MG80C6xx
Launch of AHF revision 03:
Fan control with variable speed fan.
Optimization of mechanical design.
Lifting eyes in centerlines from X3 enclosure.
Table 1.1 Document Version
1.3 Intended Use
The filters are components designed for installation in
electrical systems or machinery.
When installing in machines, commissioning of the filters
(that is starting of operation as directed) is prohibited until
it is proven that the machine complies with the Machinery
Directive 2006/42/EC. Observe EN 60204.
The VLT
®
Advanced Harmonic Filter AHF 005/AHF 010 is
intended for use with:
•
VLT
®
HVAC Drive FC 102
•
VLT
®
Refrigeration Drive FC 103
•
VLT
®
AQUA Drive FC 202
•
VLT
®
AutomationDrive FC 301/FC 302
1.4 Abbreviations, Symbols, and
Conventions
1.4.1 Abbreviations
°
C
Degrees Celsius
°
F
Degrees Fahrenheit
A
Ampere/AMP
AC
Alternating current
AHF
Advanced Harmonic Filter
AWG
American wire gauge
CDM
Complete drive module
DC
Direct current
DPF
Displacement power factor
EMC
Electromagnetic compatibility
f
M,N
Nominal motor frequency
FC
Frequency converter
g
Ground gravity
HCS
Harmonic calculation software
I
M,N
Nominal motor current
I
INV
Rated inverter output current
Hz
Hertz
kHz
Kilohertz
kVAr
Kilo-volt-ampere reactive
LCP
Local control panel
m
Meter
mA
Milliampere
MCT
Motion control tool
mH
Millihenry inductance
min
Minute
ms
Millisecond
nF
Nanofarad
Nm
Newton meters
P
Active power
PCC
Point of common coupling
PDS
Power drive system
PELV
Protective extra low voltage
PF
Power factor
P
M,N
Nominal motor power
PWHD
Partial weighted harmonic
distortion
Q
Reactive power
R
SCE
Short circuit ratio
RPM
Revolutions per minute
S
Apparent power
s
Second
TDD
Total demand distortion
THD
Total harmonic distortion
THDi
Total harmonic current distortion
THDv
Total harmonic voltage distortion
Introduction
VLT
®
Advanced Harmonic Filter AHF 005/AHF 010
4
Danfoss A/S © 05/2019 All rights reserved.
MG80C602
1
1
Содержание AHF 010
Страница 2: ......