Danfoss 45 Frame K2 Series, Руководство по обслуживанию

Страница: 29 / 40

8. Install two screws (J130) and torque to 44 N•m [32 lbf•ft].
Auxiliary mounting pads
J095
J090
J120
J110
J085
J140
J140
J085
J120
J110
J095
J090
J100 (4pl.)
J085
J095
J100 (4pl.)
J130(2pl.)
P109054
Wrench size and torque
Item Description Wrench size Torque
J085 pad adapter - -
J090 O-ring - -
J095 O-ring - -
J100 cap screw 8 mm internal hex 54 Nm [39 lbf•ft]
J110 cover plate - -
J120 O-ring - -
J130 screw 9/16 inch 44 N•m [32 lbf•ft]
J140 drive coupling 8 mm internal hex 54 Nm [39 lbf•ft]
Inspection
Inspect sealing surfaces on the endcap and auxiliary pad and make sure that they are clean and free of
contaminants. Inspect the coupling (J140) for any signs of excessive or abnormal wear. Replace all O-
rings. Replace excessively worn parts if necessary.
Assembly
1. Install the adapter (J085) with new O-rings (J090, J095). Tighten the screws (J100) at 75 N•m [55 lbf•ft].
2. Install the coupling (J140) onto the shaft.
LS and PC Controls
Disassembly
1. Remove the 4 screws (C300) holding the control housing onto the endcap.
Service Manual
Series 45 Frame K2 Open Circuit Axial Piston Pumps
Minor repair
© Danfoss | April 2017 AX00000301en-US0101 | 29