1.
Position the 2 brackets from the kit over the
mounting holes at the back of the drive enclosure.
For the location of the mounting holes, see
Illustration 1.1
.
2.
Fasten 4 M4x8mm screws (T20), 2 in each bracket.
Tighten to 2.3 Nm (20 in-lb). See
Illustration 1.2
.
3.
Each space heater has a metal mounting clip on the
back of the heater that snaps on to the bracket.
3a
Position each heater at a 45
°
angle with the
top lip of the heater mounting clip
positioned over the upper edge of the
bracket. See
Illustration 1.3
.
3b
Rotate the heater downward, pressing it
firmly onto the lower edge of the bracket
until it snaps into place.
3c
Snap the terminals onto the bracket next to
the heaters in the same manner.
4.
Attach the customer wiring to the A1 and A2
terminals on each heater.
1
Positioning upper lip of heater mounting clip over bracket
2
Rotating downward to snap into place
Illustration 1.3 Installation of Heater and Terminals on Bracket
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on
order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss
and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Danfoss A/S
Ulsnaes 1
DK-6300 Graasten
vlt-drives.danfoss.com
*MI35J102*
MI35J102
130R0762
08/2017
