1.4.3 Installing the Inrush Card in D2h/D4h/D7h/D8h Drives
To install the new inrush card, use the following steps. Refer to
.
1.
Position the inrush card in the drive.
2.
Secure 5 screws (T20) in the inrush card.
3.
Secure 2 thread-forming screws (T20).
4.
Connect the cable to the inrush card connector MK1802.
1.4.4 Reassembling D2h/D4h/D7h/D8h Drives
After installing the new inrush card, replace the following components in the drive. Refer to
. See the
service guide
for
detailed instructions for each component.
1.
Replace the power card mounting plate.
2.
Replace the control card mounting plate.
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on
order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss
and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Danfoss A/S
Ulsnaes 1
DK-6300 Graasten
vlt-drives.danfoss.com
*MI39A102*
MI39A102
130R0846
05/2018
