Danfoss 088L0028, Руководство пользователя

Страница: 6 / 12

Continuity tester
User Guide 6
5 Operation
Make sure the mats and/or cables to be monitored are
not connected to a power source .
Connect the system leads at beginning of the installation
(see Figure 3).
The Continuity tester is designed to monitor the mats or
cables individually. However, by making a temporary “se-
ries” connection of multiple mats or cables, it can monitor
up to three products at one time.
1. FOR A SINGLE MAT OR LOOSE CABLE REEL: Strip the
insula-tion around the tip of the cold cable and sepa-
rate the sheath earth wire. Insert each lead wire of
the cold cable into the L1 and L2 terminals with the
earth wire inserted into the E terminal. Tighten the
terminal screws onto the wires (as shown in Figure 3).
3. The alarm should sound and the red light should be
lit when there are no connections to an underfloor
heating mat or loose cable. If these things do not
occur, inspect the battery connection or replace the
batteries.
4. During normal use (once the mat or cable is con-
nected to the unit), the green light indicates that
Continuity tester is monitoring the mat or cable for
damage. Should the green light go out, replace the
batteries before continuing work.