Shut the machine off!
Shut the machine off! D&K Minikotes have set screws at both ends of each laminating and pull roller.
With the use of a 3/32 hex key, loosen all four set screws on the pull rollers. Cut the plastic between the
laminating and pull rollers, grab the loose end and pull. The rollers will rotate freely on the roll shafts and
the “wrap-around” will easily unwrap. Tighten all the set screws and rethread the
¿
lm.
Appendix A
Appendix A
Replacing the hand held Cutter Blades.
Replacing the hand held Cutter Blades.
The hand held cutter blade can be replaced
by removing the small screw on the back of
the cutter, then removing the cutter back.
Caution: The cutter blade is extremely
Caution: The cutter blade is extremely
sharp. Please handle carefully and dis-
sharp. Please handle carefully and dis-
pose of properly
pose of properly. Remove and discard the
old blade. Re-install cutter back and screw.
Caution: Do not over tighten screw
Caution: Do not over tighten screw.
12
Laminator.com
www.laminator.com
