5
Understanding Your Laminator
The EXP 42” Pouch Laminator is a professional laminator designed for ease of use. The process
temperature has been preset to eliminate operator guesswork. The factory settings will facilitate good
quality results using SuperStick® brand Flexible Pouches and Pouch boards. The EXP 42” Pouch can
handle Flexible Pouches and Pouch boards up to 42 inches wide and
½
” thick.
Unpacking, Setup and Installation
1.
Open the box and lift the machine out (at least two persons necessary!). Grasp the machine 8-10”
(200mm-250mm) from either side.
2.
Place the machine on the work area described in the previous page.
3.
Remove the protective sheet, placed between the rollers. To do this: pull the knob fully outward
(located on the left side of the machine) and rotate clockwise.
4.
Inspect the machine for any physical damage (if damage does exist, report this to the Freight
Company or Dealer to file a claim.)
5.
Plug the power cable into the grounded outlet with appropriate service as described in the previous
page.
6.
Wait 10-15 minutes to allow the unit to achieved operating temperature.
7.
When the (heat) LED is blinking, you are ready to use your EXP 42” Pouch laminator.
NOTE: Set the nip to a position other than fully closed when not in use.
NOTE: The laminator may emit steam the first few times it is used. There is no need for alarm. This is
normal (relates to the lubrication system) and will cease after several minutes of use.
