D&B D6, Руководство по оборудованию

Страница: 10 / 20

4. Connections
D6
VOLTAGE SEE LABEL
~ 50/60 Hz, 1000 W
MAINS SUPPLY
DIGITAL AES/EBU ANALOG
OUT
B
OUT
A
CH A
CH B
SERVICE REMOTE
4.1. Mains Connector
The D6 is a protective class 1 unit.
WARNING!
A missing earth (ground) contact may lead to dangerous
voltages in the housing and controls and may lead to electric
shock.
- The unit must only be connected to mains voltage supply with
protective earth.
D6
VOLTAGE SEE LABEL
~ 50/60 Hz, 1000 W
MAINS SUPPLY
DIGITAL AES/EBU ANALOG
OUT
B
OUT
A
CH A
CH B SERVICE REMOTE
D6
ÉZ2700.000WË
D6
100-127V / 220-240V
Z270000000001 WEEE
0615
A PowerCon
®1
mains connector [8] is fitted on the rear panel and an
appropriate mains lead is supplied.
Before connectingthe device to mains voltage, check that the mains
voltage and frequency correspond to the specifications on the
configuration sticker on the rear of the D6.
CAUTION: For any sign of obvious damage to the power cord and or
mains connector the power cord must not be used and must be
exchanged before further use of the unit.
4.2. Signal inputs and link outputs
NOTICE:
To meet the EMC requirements only shielded cablingand
proper fitted connectors must be used.
4.2.1. INPUT A/B and LINK A/B
Fig. 2: Pin assignment ANALOG INPUT/LINK
A 3 pin female XLR input connector [9] is provided for channel A and B.
The inputs are electronically balanced.
Wired in parallel is a 3 pin male XLR input link connector [10] used to
feed the input signal on to the next device in the system signal chain.
1 PowerCon
®
is a registered trademark of the Neutrik AG, Liechtenstein
D6 Amplifier, Hardware manual (1.2EN) Page 10 of 20