d&b audiotechnik Z5555, Инструкция по монтажу

Страница: 6 / 12

1.5 Z5555 Assembly
Attaching the bracket to ceilings
NOTICE!
Only use mounting parts (fixing anchors and screws) that are
suitable for the intended application.
Observe the occurring extraction forces acting on the fixing
anchors and screws.
Observe the occurring extraction forces acting on the fixing
anchors and screws. The rated extraction forces for the respective
application (wall or ceiling mounting) and cabinet are listed in the
following table.
Application Rated extraction forces
1 x 21S-SUB 620 N
2 x 21S-SUB 1200 N
To attach the bracket to the ceiling, use the holes shown in the
graphic opposite to provide adequate support.
A corresponding fixing template is supplied with these mounting
instructions. Refer to
Þ
Chapter 2 "Z5555 Fixing template"
on page 9.
Preparing the cabinet
The threaded inserts of the cabinet are covered by dummy caps in
cabinet color. To remove the caps, proceed as follows:
1. Cut out the caps along the recessed spline using an
appropriate cutting knife.
2. Carefully take off the caps and ensure the cabinet coating is
not peeled off.
d&b Z5555/Z5556 Mounting instructions 1.2 en 6