Z5150
(2.0E)
Page 3 of 4
Z5150 Q Swivel bracket
The L shaped Z5150 Q Swivel bracket allows a d&b Q7
loudspeaker cabinet to be mounted and set to a variety of
horizontal or vertical angles.
Using the Z5024 Loudspeaker stand adapter together with the Q
Swivel bracket enables a Q7 loudspeaker to be mounted onto a
loudspeaker stand (e.g. Z5013, Z5009 or E6001) with a tube
diameter of 35 mm/1.4”.
The Z5150 Q Swivel bracket allows single Q7 cabinets to be flown
vertically using the Z5010 TV spigot with fixing plate or the Z5029
TV spigot. Both can be used in conjunction with the Z5012 Pipe
clamp for hanging cabinets from overhead bars or truss with a
tube diameter between 32 mm to 50 mm (1.25” to 1.97”).
Safety instructions
[S]
[F]
DO NOT
UNLOCK PIN TO
ADJUST ANGLE
CAUTION
ONLY UNLOCK FOR
DISASSEMBLY ON
GROUND
WARNING!
Installation should only be carried out by fully
trained personel. There are certain rules for
installation that must be complied with.
It is essential to secure the cabinet with the securing
pin [S] before lifting the cabinet or placing it onto a
loudspeaker stand.
The bracket and loudspeaker must have all locking
devices (fixing screw [F] and the securing pin [S])
secured when in use.
Under no circumstances should the securing pin [S]
be unlocked to adjust the vertical angle of the
cabinet.
Secondary safeties must always be provided and used
when flying or fixing loudspeaker loads overhead.
Load safety information
WARNING!
The Z5150 Q Swivel bracket is designed to support
one d&b Q7 loudspeaker cabinet.
No additional loads must be added.
The bracket may only be used in an upright position
or suspended vertically.
Part list Z5150 Q Swivel bracket
[S]
[1]
−
1 x Z5150 Q Swivel bracket
[1]
with securing
pin
[S]
that is
attached to the bracket by a steel wire.
Weight Z5150 Q Swivel bracket
2.5 kg/5.5 lb
