d&b audiotechnik Z Series, Инструкция по монтажу

Страница: 5 / 14

1.3. Intended use
The d&b Z5404/05/06 Flying bracket 8S/10S/12S must only be
used in conjunction with the d&b xS-Series loudspeakers 8S, 10S/
10S-D and 12S/12S-D as described in these mounting instructions.
The bracket can be:
▪ directly mounted to ceilings.
▪ vertically flown and mounted to bars and truss with a tube
diameter of up to 70 mm (2.75") using the Z5010 TV spigot
and the Z5012 Pipe clamp.
Note: Refer to the specific mounting instructions for assembly
and operation of these accessories.
1.4. Mounting options and angle settings
Mounting holes are provided on the tie bar of the bracket.
Two 6.5 mm (0.25") holes are provided onn the tie bar for fixing
the bracket directly the ceiling.
Two M8 threaded inserts at the d&b standard spacing of 115 mm
(4.5") are provided to allow the attachment of the Z5010 TV
spigot.
Vertical angles can continuously be set in the range of 90°.
1.5. Assembly
Fixing the bracket to the ceiling
NOTICE!
Only use mounting parts (fixing anchors and screws) that are
suitable for the intended application.
Observe the occurring extraction forces acting on the fixing
anchors and screws. The rated extraction forces for the respective
cabinet are listed in the following table.
Application Rated extraction forces
8S 10S 12S
Ceiling mounting 100 N 250 N 300 N
To attach the bracket to the ceiling, use the holes shown in the
graphic opposite to provide adequate support.
A corresponding fixing template is supplied with these mounting
instructions. Refer to
Þ
Chapter 2. "Fixing templates"
on page 7.
Fig. 2: Z5404/05/06 Rigging examples
Fig. 3: Z5404/05/06 Mounting holes
d&b Z5404/05/06 Mounting instructions 1.1 en 5