d&b audiotechnik Q10, Руководство пользователя

Страница: 4 / 10

Q10
Fig. 1: Q10 loudspeaker
The Q10 is a 110° x 40° passive two-way loudspeaker. It houses 2 x 10"
LF drivers and a 1.3" HF compression driver with a rotatable CD horn
and a passive crossover network. Its frequency response extends from
60 Hz to above 17 kHz. The two 10“ neodymium LF drivers are
positioned in a dipolar arrangement providing exceptional vertical
dispersion control even at lower frequencies.
The Q10 cabinet is constructed from marine plywood and has an impact
resistant paint finish. The front of the loudspeaker cabinet is protected by
a rigid metal grill, covered with a replaceable acoustically transparent
foam. The cabinet incorporates a pair of handles.
The Q10 cabinet is fitted with four types of rigging device:
- Eight sockets in the front grill and rear edge bar, that accept the
Z5153 Locking pins 8 mm, to connect the array links.
- A quick lock adapter plate on one side of the cabinet that accepts the
Z5150 Q Swivel bracket or the Z5156 Q Flying adapter.
- Five sockets that accept the Z5048 Flying pin 10 mm for supporting
single cabinets and for the aiming of arrays.
- Four M10 threaded inserts to accept the Z5020 Flying adapter 02,
Z5025 Flying adapter 03 or Z5043 MAX Horizontal bracket.
CAUTION!
Only operate Q10 loudspeakers with a d&b amplifier configured for
the Q10 otherwise there is a risk of damage to the loudspeaker
components.
Connections
1
2
3
4
5
1
2
3
4
5
passive
crossover
Fig. 2: Connector wiring
The Q10 cabinet is fitted with a pair of EP5 connectors. All five pins of
both connectors are wired in parallel. The Q10 uses the pin assignments
1/2. Pins 3/4 and 5 are designated to Q-SUB active subwoofers, where
pin 5 is used for SenseDrive (only available when using a D12 amplifier
and 5-wire cabling). Using the male connector as the input, the female
connector allows for direct connection to additional loudspeakers.
The Q10 can be supplied with NL4 output connectors as an option. Pin
equivalents of EP5 and NL4 connectors are listed in the table below.
EP5
1 2 3 4 5
NL4
1+ 1− 2+ 2− n.a.
Tab. 1: EP5 and NL4 pin assignments
Q10 Manual (1.3E) Page 4 of 10