LED indicators
Each etherCON
®
connector provides the following LED indicators:
[3a]
Ethernet link/Activity indicator (green).
[3b]
Ethernet Gigabit indicator (yellow).
[3c]
Switch port mode indicator (RGB-LED).
The color coding is as follows:
▪
Magenta: PRImary.
▪
White: SECondary.
In addition, the switch mode indicator on each port flashes when
the signal bridge detects a subscribed audio channel is not
available on that port, in this way allowing for faster network
troubleshooting. For example, if the Secondary link of the mixing
console is interrupted, the switch mode indicators of the ports
configured as Secondary will flash.
3.4.4 Mode push button
Apart from the Milan Controller software, the device can also be
configured locally via the «Mode» push button.
Briefly pushing the button enters IDENTIFY mode
Þ
Milan
Controller.
To configure the device locally, proceed as follows:
1. Push the «Mode» button for 2 seconds.
↳The device enters configuration mode with the current mode
selected and all LEDs will flash.
2. To set the desired configuration (switch mode), briefly push the
«Mode» button to step through the different switch modes.
The following switch mode order will apply:
Default:
PRI/SEC - Bypass off.
PRI:
All - Bypass off.
PRI/SEC:
Bypass on (
Þ
SUBSCRIBED LED flashes).
PRI:
All - Bypass on (
Þ
SUBSCRIBED LED flashes).
3. Once the desired switch mode is selected, wait for 5 seconds.
↳The set mode will be applied automatically.
3.4.5 BYPASSED/SUBSCRIBED/IDENTIFY/SYNC ERROR
BYPASSED
Flashes green when the device is BYPASSED.
The digital inputs are routed (with negligible
latency) to all outputs. That means Inputs 1-4
are routed simultaneously to outputs 1-4, 5-8,
9-12 and 13-16.
SUBSCRIBED
Illuminates green, when any of the signal
bridge outputs has a configured subscription.
IDENTIFY
Flashes red to physically identify each DS20
when there is more than one device on the
network.
SYNC ERROR
Illuminates red, when the signal bridge cannot
synchronize to the Milan network.
d&b DS20 Manual 0.1 en
- preliminary -
10
