WR cabinets are equipped with a recessed connector panel
including 4-pole Phoenix connector socket (Type: DFK PC 4/4
GF). A cover plate which accepts single or dual PG cable glands
(Type PG13.5 for cable diameters from 6 - 12 mm) is enclosed.
NOTICE!
The WR option enables operation of loudspeakers in changing
ambient conditions, however it is not intended to enable
permanent, unprotected operation of loudspeakers outdoors.
▪ Provide an additional cover over the loudspeakers.
▪ Aim the cabinets either horizontally or with a downward tilt.
To install the fixed connection cable, please proceed as follows:
Tools required: Screw driver (#T20).
Note: Observe the wiring diagram of the Phoenix plug and
Phoenix connector socket.
1. Insert the connection cable through the PG screwing and
connect the Phoenix plug to the Phoenix connector socket.
2. Push the cover plate towards the connector panel until it fits
into place.
3. Fix the cover plate to the connector panel using the four
countersunk screws.
2.3 Operation
NOTICE!
Only operate d&b loudspeakers with a correctly configured d&b
amplifier, otherwise there is a risk of damaging the loudspeaker
components.
Applicable d&b amplifiers:
30D/D20/D80.
Amplifier output mode(s): Dual Channel
Application
Setup
Cabinets per
channel
ALi60
AL60 PS
AL60 Out
AL60 In
2
2
2
AL60 AP
1
ALi90
AL90 PS
AL90 Out
AL90 In
2
2
2
AL90 AP
1
Phoenix connector socket, male single PG (standard), dual PG
(optional)
d&b ALi60/ALi90 Manual 1.1 en
7
