d&b audiotechnik 8S, Руководство пользователя

Страница: 5 / 12

2.1 Product description
The 8S loudspeaker is a full range, two-way bass-reflex enclosure,
utilizing an 8"/1" coaxial driver combination with a passive
crossover. Coaxially mounting the 1" HF compression driver and
8" LF driver using a single magnet assembly creates a very
compact driver with 100° constant directivity HF dispersion.
With a frequency response extending from 70 Hz to 20 kHz, the
cabinet can be used as a full range system or supplemented by
different subwoofers of the xS- or xA-Series.
The enclosure is constructed from marine plywood with an impact
resistant black paint finish. The front of the loudspeaker cabinet is
protected by a rigid metal grill backed by an acoustically
transparent foam
The 8S rear panel incorporates two M8 threaded inserts to accept
the Z5402 Wall mount M, the Z5403 Wall mount L or the Z5404
Flying bracket 8S. The top and bottom panels are each equipped
with an M8 thread to accept the Z5408 Horizontal bracket 8S.
The threads are covered by dummy caps in cabinet color. The caps
must be removed before mounting any accessories.
2.2 Connections
The cabinet is fitted with a pair of NL4 connectors and a two pole
screw terminal block (ST - cross-section up to 4 mm
2
/AWG 11). All
four pins of both NL4 connectors are wired in parallel. The cabinet
uses the pin assignments 1+/1–. Pins 2+/2– are designated to
active subwoofers.
Pin equivalents of the applicable connector options are listed in the
table below.
NL4 1+ 1– 2+ 2–
ST
+ – n.a. n.a.
Fixed cable connection
The 8S loudspeaker is supplied with a cover plate
[1] and a
rubber grommet feed through
[2]. For indoor operation, these
items can be used to hide the connector panel, if required. For
unprotected outdoor operation, the connector panel must be
covered, i.e. both items must be used to achieve an IP degree of
protection of IP34.
Fig. 1: 8S loudspeaker
Rigging examples:
8S with Z5404 Flying bracket, Z5010 TV spigot
and Z5012 Pipe clamp.
8S with Z5403 Wall mount L.
Fig. 2: Connector wiring
Fig. 3: Cover plate and rubber grommet
2 8S loudspeaker
d&b 8S Manual 1.4 en 5