3.
On each end of (no. 3), install the Leg (no. 1). Repeat step 1 for all frames.
4.
At this point stand up the front or back frame and add 7 male connecting pipes (no. 8). Then stand up
another frame and add 7 female connecting pipes (no. 2). For the remaining frames use the male
connecting pipes (no. 8).
5.
Add the diagonals (no. 9) to the first and last legs (no. 1).
Note: Make sure all screws are tight. Do not over-tighten.
6.
ROOF ASSEMBLY
Take the roof and place it over the structure. Make sure
that the windows are on the two sides of the shelter, at
front or at back as your choice.
Tie all the ropes around the pipes.
7.
SHELTER REINFORCEMENT
Before you install the floor brackets, make sure the
distance between the legs is 18 feet wide.
Place the floor brackets (14) at each end of the shelter.
Then drive in nails (15) into ground, gravel or asphalt.
Other material surfaces require other types of anchoring
(cement blocks, sand bags, screw and bolt, etc). Permanent
anchors are not provided with this unit.
8.
DOOR INSTALLATION
Install doors at each end. Connect door with roof by velcro
as shown. Use elastics (13) to attach the door to the roof
with hooks (11). Close the end of hook on the elastic so it
won’t fall on out. Use the rail hooks to attach door the door
rails. When closing at the front, make sure all elastics are
attached on the inside and outside of the shelters.
Содержание 5.4m Series
Страница 1: ...14 12 2017 for Garage Tent 5 4m Series Manual ...
Страница 7: ......
