8
7
Install horizontal tail and vertical tail on the
fuselage as shown, fasten the joint with
epoxide-resin glue.
Overturn to the underside, tighten the
vertical tail with 2pcs screws.
Here please use epoxide-res-
in glue to fasten the needle
type hinge.
Here please use epoxide-res-
in glue to fasten the needle
type hinge.
Glue the connecting pole on the horizontal tail, then glue the
elevator on the tail wing, fasten with epoxide-resin glue.
Please keep the surface can swing freely in glueing.
Use a little lubricant oil on the moving part of connecting pole,
avoid the glue stuck dead.
1
2
3
4
5
6
7
8
Through
Through
The stay wire is a piece of thread,
thread the wire according to the
numerical order.
Pay attention to some fixed
details as shown.
Install stay wire's stabilizer rod in
the middle of stay wire.
Install other half wing with the
same steps in above, assemble stay
wire symmetrically.
About the installa-
tion way of stay
wire's stabilizer rod,
please see
picture---"Details 4".
All wires through
the reserved hole,
Details 1
Details 3
Details 4
Details 2
02-20
Aluminum
buckle
Aluminum
buckle
Aluminum
buckle
Fastener
Fastener
Fastener
Spring
Spring
03
Tail wing installation
Add some lubricating oil in the joint of
needle type hinge.(Avoid the glue
stuck dead.)
Before install and fasten needle type
hinge with epoxide-resin glue ,
please confirm the surface can swing
freely in advance.
Lubricant oil
03-1
03-2
03-3
03-4
Epoxy glue
Epoxy glue
Epoxy glue
03-5
Epoxy glue
Install stay wire
retaining ring
on the position
as shown.
Note the ring's
direction.
02-18
02-19
Add a little CA glue into the
reserved hole, tighten screws
after the glue dries.
Nut
Nut
Self-locking nut
Self-locking nut
Screw for
the ring
Screw for the ring
Here please use epoxide-res-
in glue to fasten the needle
type hinge.
