03
Assemble the Wing
4
3
When steps 02-8 and 02-9 are fixed with self-tapping screws,
drill holes at the pre installed hole position with a drill bit.
When installing the flap, drill holes in the reserved screw holes, and
then tap a small amount of CA glue. After curing, screw in the
self-tapping screws to install the hinges, so that the flaps can swing
freely.
Install the servo horn at the servo horn holes of the aileron
and flap. As shown in the figure below.
10mm
02-3
02-4
02-5
02-6
02-7
02-8
02-9
Epoxy glue
Lubricant oil
Lubricant oil
Adjust to be
perpendicular to
each other
Spring
Spring
02-10
03-2
03-3
03-1
Self-tapping screw
M3x10mm
Self-tapping screw
M3x20mm
G1
G2
G2
Epoxy glue
Epoxy glue
Epoxy glue
Aileron
Flap
Self-tapping screw
M2x10mm
03-4
Hand screw
M4x20mm
M2
M1.5
Ø10x270mm
SCG40-D
SCG40-B
Aileron
Flap
