机翼拼装 Assemble the Wing
6
把舵机通电回中，并安舵臂。
Supply power for the servo
and return it to center,install
a servo horn.
参考前面制作连杆的步骤做好两个短连杆。
Refer to the previous steps of making connecting
rod to make two short connecting rods.
把制作好的一端Z型头穿入舵机的舵臂，然后参考副翼上舵角的位置，确定
连杆合适的长度，并切除多余的碳杆。
Insert the finished Z-shaped end into the rudder arm of the steering
gear, and then refer to the position of the rudder horn on the tail to
determine the appropriate length of the connecting rod, and cut off
the excess carbon rod.
然后对照连杆制作步骤安装另一端的Z型头。
Then follow the steps to make the Z-shaped head at the other end
of the connecting rod.
完成Z型头后，把Z型头穿入舵角，把舵角用泡沫胶粘在舵面上。
After finishing the Z-shaped head, insert the Z-shaped head into
the rudder horn, and glue the rudder horn to the rudder surface
with foam glue.
03-8
03-7
03-6
按右机翼拼装步骤完成左机翼拼装。
Follow the right wing assembly steps to complete the left
wing assembly.
03-5
在机翼背面预留槽内粘贴舵机，并把舵机线导入机翼内，从侧面导出。
Paste the servo in the reserved slot on the back of the wing, guide
the servo line into the wing and lead it out from the side.
在副翼预留孔处安装舵角，泡沫胶粘固。
在翼肋凹槽内粘贴碳杆，如上图所示。
Stick the carbon rod in the wing rib
groove as shown in the picture above.
03-1
03-2
03-3
CA
CA
CA
03-4
CA
翻折并粘固
Fold and glue
02-11
然后对照连杆制作步骤安装另一端的Z型头。
Then follow the steps to make the Z-shaped head at the other end of the connecting rod.
把Z型头穿入舵角，然后用热缩管固定住。点入少量CA胶粘固。
Penetrate the Z-shaped head into the servo horn, and then fix it with a heat-shrinkable tube. Add a small amount of CA glue
to cement.
把两根碳杆插入机翼。
Insert two carbon rods into the wing
用尺子确定碳杆伸出15mm
Use a ruler to determine that the carbon rod extends for 15mm
B1
W2
W2
W2
W2
W2
W1
15mm
15mm
F
F
E2 碳杆
Carbon Rod
Ø1.0x50mm
E1 碳杆
Carbon Rod
Ø1.5x227mm
F
E1 碳杆
Carbon Rod
Ø1.5x70mm
5
