12.用桨夹把桨叶固定到马达上，然后把马达安装马达座上，用螺丝
固定马达。
Fix the propeller with adapter,install the motor onto the motor
mount and fix with screws.
舵机线埋入
Bury the servo wires
螺丝
screws
13.把步骤11装好的马达固定到机身头部，并卡入预埋的碳片内以固定
住，用泡沫胶粘合加固。
Install the motor onto the head of the fuselage,stuck into the
pre-bury carbon plates,finally seal with foam glue.
14.在另外一面，嵌入2个碳片并卡住马达座，调整马达到合适角度后，
用胶水粘合固定住。
On the other side,insert two carbon plates and stuck the motor
mount,adjust the motor at suitable angle and fix with glue.
15.从木件L上取下如下部件，如图拼装在一起，组成起落架固定座。
然后把钢丝起落架嵌入固定住。各连接部件用502胶水粘合。
Take off the following parts from wood L,and assemble as a
landing gear mount;Insert the steel wire landing gear and glue
at junctions with 502.
16.把装好的起落架安装到机身，用泡沫胶粘合固定。
Install and glue the landing gear onto the fuselage.
17.在起落架钢丝上安装机轮。
Install the wheels on the steel wire of the landing gear.
18.安装电子设备。下图标记出电子设备安装位置，供参考。
Install the power system,mark out the suggested positions for
your reference as picture shown below.
19.调整飞机重心，即可试飞。
Adjust the C.G,and test flight.
ESC
battery
电调线埋入
Bury the ESC wires
≈70mm
C.G
finish
