10
9
06
Installation
机翼拉线安装
07
引擎安装示范
Assemble the engine
防火墙四周，用三角木加固，用环氧胶粘固。
Strengthen the firewall with triangle wood around and
stick with epoxy glue.
1
3
2
1
3
2
机翼拉线为上下各两根钢丝绳，从1起如图穿过2在3处止，钢丝绳两端点用铝扣打结。
There are each 2pcs steel bracing wires up and down, start at "1" as above picture
shown,
pass through "2",until end at "3".Use alu buckle to tie a knot on both ends.
机翼拉线以一边为例，左右相同安装。
Installation for the wing bracing wire
Take the one side wing bracing wire as an example, the left and right installation in same method.
调整安装好引擎后，调整前起落架伸出长度，调整到不干涉桨叶止，然后在图示螺丝位置钻孔，最后用螺丝固定起落架。
After installation and adjustment of engine, adjust the extension length of landing gear,
until without influence for propeller, then drill holes on the screw position as shown, fasten the landing gear with screw lastly.
F25-1
F25
F25-2
F25-2
M3
Screw
+nut
螺丝M3*15mm+螺母
X4
自攻螺丝
Self-tapping screw
M3x10mm
X2
