OPERATING INSTRUCTIONS
FUNCTION INSTRUCTION
The default temperature setting in both chambers is
12°C. The temperature can be set as low as 5°C or
as high as 18°C.
Actual temperature inside the appliance can vary
based on ambient temperature, how often the
door is opened and how many warm bottles have
recently been added to the appliance.
Temperature Memory:
If the appliance loses power,
the control panel will remember the set temperature.
Once power is restored, the appliance will return to
normal functioning automatically.
Temperature Alarm:
If the inner cabinet temperature
is higher than 23°C for one hour, the error code
“HI” will show on the display panel and an alarm
will sound.
If the inner cabinet temperature is lower than 0°C
the error code “LO” will show on the display panel
and an alarm will sound.
Door Ajar Alarm:
If the door is not closed
completely for 5 minutes, an alarm will sound. Close
the door to silence the alarm.
If the door is closed and the alarm continues to
sound, check that the actuator at the bottom of
the door is making contact with the switch on the
appliance.
Demo Mode:
Demo mode can be used to show how
the appliance will look while functioning without
running the compressor. The fan will run on low
speed but all alarms and beeping will be disabled.
To engage demo mode, press and hold the up and
down buttons at the same time for 10 seconds.
The display will fl ash “dE” and “On” fi ve times to
acknowledge demo mode is active.
To disengage demo mode, press and hold the up
and down buttons at the same time for 10 seconds.
The display will fl ash “dE” and “Of” fi ve times to
acknowledge demo mode is disabled.
5
INTERIOR LIGHT
The interior light will default to turning on and off
when the door is opened or closed.
Press and hold the light button for 5 seconds until
the display shows “LP” to set the light to continuous
illumination. After 4 seconds the display will return
to normal operation and the light will remain on
until manually turned off.
To resume normal light function, press and hold the
light button for 5 seconds until the display show
“LF”. After 4 seconds the display will return to
normal operation and the light will be set to turn on
and off when the door is opened and closed.
CONTROL PANEL
1. Power indicator light:
Illuminates to signify that
the compressor is in operation.
2. Power button:
Press this button to turn the
appliance on. Press and hold this button for 3
seconds to turn the appliance off.
3. Upper display:
Shows the set temperature in the
upper chamber.
4. Lower display:
Shows the set temperature in the
lower chamber.
5. Upper chamber button:
Used to adjust the
temperature setting in the upper chamber in
1° increments. Press and hold for 3 seconds
to display the actual temperature inside the
cabinet. After 5 seconds the display will resume
normal operation.
6. Lower chamber button:
Used to adjust the
temperature setting in the lower chamber in
1° increments. Press and hold for 3 seconds
to display the actual temperature inside the
cabinet. After 5 seconds the display will resume
normal operation.
7. Light button
RUN
C
C
1
2
3
4
5
6
7
