Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS!
GROUNDING INSTRUCTIONS
This appliance must be grounded. Grounding
reduces the risk of electrical shock by providing an
escape wire for the electrical current.
This appliance has a cord that has a grounding
wire with a 3-prong plug. The power cord must be
plugged into an outlet that is properly grounded.
If the outlet is a 2-prong wall outlet, it must be
replaced with a properly grounded 3-prong wall
outlet. The serial rating plate indicates the voltage
and frequency the appliance is designed for.
WARNING -
Improper use of the grounding
plug can result in a risk of electric shock.
Consult a qualifi ed electrician or service agent
if the grounding instructions are not completely
understood, or if doubt exists as to whether the
appliance is properly grounded.
Do not connect your appliance to extension
cords or together with another appliance in the
same wall outlet.
Do not splice the power cord.
Do not under any circumstances cut or remove the
third ground prong from the power cord. Do not
use extension cords or ungrounded (two prongs)
adapters.
If the power supply cord is damaged, it must be
replaced by the manufacturer, its service agent or
similar qualifi ed person in order to avoid hazard.
2
LOCATION
Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance with
a soft, dry cloth and the inside with a lukewarm wet
cloth.
Place the appliance on a fl oor that is strong enough
to support it when it is fully loaded.
Do not place the appliance in direct sunlight or near
sources of heat, such as a stove or heater, as this
can increase electrical consumption. Extreme cold
ambient temperatures may also cause the appliance
to perform improperly.
Do not use the appliance near water, for example in
a wet basement or near a sink.
This appliance is intended for household use only.
It is not designed for outside installation, including
anywhere that is not temperature controlled
(garages, porches, vehicles, etc.).
Before connecting the appliance to a power source,
let it stand upright for approximately 6 hours. This
will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
This appliance is 59.5 cm wide by 82 cm high by
60 cm deep.
