Adapting blower for back exhaust
1. Remove the screws that secure
the blower motor. Lift up the
blower plate.
2. Remove part A with tin snips or
scissors.
3. Pull out the blower unit. Be
careful not to stretch the wires
and make sure the wires do not
get pinched. Rotate the blower
so that it faces toward the back
and replace it in the appliance.
The blower unit exhaust
openings should match the
exhaust openings on the rear of
the microwave.
4. Close the blower plate. Attach
the exhaust adapter to the back
of the microwave by sliding
it into the guides at the top.
Push in securely until the screw
holes are visible. Ensure that
the damper hinge is installed
so that it is at the top and the
damper swings freely.
5. Secure the blower motor with
screws. Secure the blower plate
with screws.
1
2
3
4
5
A
INSTALLATION INSTRUCTIONS
Using the top cabinet template
There are instructions on the top
cabinet template that detail how it
should be used.
Tape the top cabinet template to the
under side of the cabinet where the
microwave will be installed.
Drill holes for the top support
screws and a hole large enough for
the power cord to fi t through.
17
