4
Ice Cube Tray
Ice cube tray is flexible. Twist tray to remove ice cubes. If
the ice cube tray is frozen hard to the evaporator surface,
run a little water over the tray. Never use a knife or other
metal instrument to remove ice cube tray because this may
damage the evaporator.
(Fig. D)
Fig. D
Cooling System
This refrigerator is inclusive of a “frost free” type cooling
system, which means you never have to defrost the
freezer compartment. Defrosting is done automatically by
means of a defrost heating element and a defrost timer
factory programmed to operate (cycle) approximately
every 8 hours. The defrost water is routed into a defrost
pan located directly above the compressor from where it
evaporates.
Cleaning
Before cleaning the refrigerator or freezer, always
disconnect the refrigerator from the power supply.
To
clean the inside, use a soft cloth and a solution of a
tablespoon of baking soda to one quart of water, or a mild
soap suds solution, or some mild detergent. Wash ice
cube tray, drip tray, and glide out shelves in a mild
detergent solution, then dry and wipe with a soft cloth.
Clean the outside with a soft damp cloth and some mild
detergent or appliance cleaner.
Setting the Thermostat
The thermostat setting can be adjusted from #1 (minimum
setting) through Maximum (coldest setting) We recommend
setting the thermostat at # 4 (medium setting) If however
you find this setting inappropriate for your cooling
requirements, adjust as needed by rotating the thermostat
dial. The thermostat dial is located on the front top section
of the refrigerator compartment. The thermostat controls
temperature for both the freezer and refrigerator
compartments.
Vacation Time
For short vacation periods, leave the control knob at the
usual setting. During longer absences;
(a) remove all foods,
(b) disconnect from electrical outlet,
(c) clean the refrigerator thoroughly, including defrost pan,
(d) leave door open to avoid possible formations of
condensate, mold or odors.
Power Failure
Most power failures are corrected within an hour or two
and will not affect your refrigerator temperatures.
However, you should minimize the number of door
openings while the power is off. During power failures of
longer duration, take steps to protect your food by placing
dry ice on top of packages.
If You Move
Remove or securely fasten down all loose items inside the
refrigerator. To avoid damaging the leveling legs, turn
them all the way into the base.
Some Important Rules for the
Correct Use of the Refrigerator
• Never place hot foods in the refrigerator.
• Beverages should be stored in sealed containers.
• Foods to be stored for a long time should be wrapped in
cellophane or polyethylene, or kept in glass containers.
Never place spoiled foods in the cabinet.
• Don’t overload the cabinet.
• Don’t open the door unless necessary.
• Should the refrigerator be stored without use for long
periods it is suggested, after a careful cleaning, to leave
the door ajar to allow the air to circulate inside the
cabinet in order to avoid possible formations of
condensate, mold or odors.
Food Storage Suggestions
Fresh Food Compartment
• Never cover food compartment shelves with aluminum
foil or any other shelf covering material which may
prevent
air circulation.
• Always remove porous store wrapping paper from
meats, poultry and fish. Meats should be wrapped
individually
and placed in a dish for storage. Wrap fish and poultry
in foil or heavy waxed paper. Most fish should be used
the same day of purchase. Packaged meats such as
ham, bacon, dried beef, or frankfurter, store best in their
original packages.
• Allow warm foods to cool to room temperature before
placing them in the refrigerator.
• Always cover open dishes of food, especially leftovers.
Use leftovers within 2 or 3 days.
Vegetable Crisper
The tray at the bottom of the refrigerator is covered to retain
moisture. The crisper compartment will enable you to store
vegetables and fruits which would otherwise dry out rapidly.
The humidity level inside the crisper drawer can be
controlled by adjusting the “damper” control (white slider)
located on the front of the drawer.
Care and Maintenance
